12 Wright Screwdrivers
Fits (6) slotted screwdrivers and (6) Phillips screwdrivers.
May be trimmed to fit a variety of drawer sizes.
14 X 20 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 12 Wright screwdrivers:
1/8 X 3 (Wright 9112)
3/16 X 4 (Wright 9115)
1/4 X 1-1/2 (Wright 9122)
1/4 X 6 (Wright 9124)
5/16 X 6 (Wright 9125)
3/8 X 8 (Wright 9135)
P0 X 3 (Wright 9103)
P1 X 3 (Wright 9104)
P2 X 1-1/2 (Wright 9101)
P2 X 4 (Wright 9105)
P2 X 8 (Wright 9108)
P3 X 6 (Wright 9106)
This tool organizer insert may be trimmed to fit a variety of drawer sizes. The minimum size is marked on the drawing (see link below).
14 X 20 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 12 X 16-7/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.