Home |
About |
FAQ |
Shipping Policies |
Extras and Deals |
Custom Options |
Contact Us
Foam Tool Organizer for
37 Husky Metric Combination, Ratcheting, and Midget Wrenches
Overview
37 Husky Metric Combination, Ratcheting, and Midget Wrenches
Fits (20) combination wrenches, (7) non-reversible ratcheting wrenches, and (10) ignition wrenches.
Accommodates all metric wrenches from the Husky 505-pc set H505MTSPO.
Drawer Size
31-7/8 X 18-1/2 inches
$81.90
Details
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 37 Husky wrenches:
metric combination:
5.5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
21
22
24
25
27
metric non-reversible ratcheting:
10
12
13
14
15
17
18
metric ignition wrenches:
4
4.5
5
5.5
6
7
8
9
10
11
This tool organizer was designed to fit the metric wrenches from the Husky 505-pc set H505MTSPO.
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Drawer Size
This organizer is designed to fit a toolbox drawer with inner dimensions of:
31-7/8 X 18-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 31-5/8 X 16-3/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-04543-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
