11 Tekton Pliers with Channellock Tin Snips
Fits (4) pliers, (4) mini pliers, (2) locking pliers, wire stripper, and tin snips.
May be trimmed to fit a variety of drawer sizes.
24 X 18 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 12 Tekton and Channellock tools:
7 inch wire stripper (Tekton 3797)
7 inch long nose pliers (Tekton PGF10007)
6-1/2 inch slip joint pliers (Tekton 37122)
7 inch diagonal cutting pliers (Tekton PCT00007)
10 inch groove joint pliers (Tekton 37524)
10 inch curved jaw locking pliers (Tekton PLK10010)
6 inch long nose locking pliers (Tekton PLK30006)
mini long nose pliers (Tekton PMN11001)
mini flat nose pliers (Tekton PMN21001)
mini diagonal cutting pliers (Tekton PMN54001)
mini bent long nose pliers (Tekton PMN11301)
10 inch straight pattern tin snips (Channellock 610TS)
This tool organizer insert may be trimmed to fit a variety of drawer sizes.
24 X 18 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 20-5/8 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.