18 Craftsman Inch Wrenches with 2 Adjustable Wrenches
Fits (7) inch combination wrenches, (11) non-reversible ratcheting wrenches, and (2) adjustable wrenches.
Accommodates the inch wrenches and half of the adjustable wrenches from the 543-pc mechanics set CMMT72000.
Only fits newer Craftsman wrenches with diagonal markings and part numbers that begin with "CMMT".
22-1/4 X 16-1/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 20 Craftsman tools:
non-reversible ratcheting wrenches:
8-inch adjustable wrench
10-inch adjustable wrench
This tool organizer was designed to fit the inch combination wrenches and inch reversible wrenches from the Craftsman 543-pc set CMMT72000. Only newer Craftsman wrenches with diagonal markings will fit. It also fits the 8-inch and 10-inch adjustable wrenches from the 543-pc set.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-5/8 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.