76 Craftsman Inch Gunmetal Sockets with 59 Additional Tools
Fits (20) 1/4-drive sockets, (32) 3/8-drive sockets, (22) 1/2-drive sockets, (3) ratchets, (22) hex keys, and (36) accesories.
Accommodates the inch sockets and a portion of the drive tools from the Craftsman 282-piece gunmetal chrome mechanics tool set CMMT45282.
Caution: Recommended for a 3 inch or deeper drawer.
22-1/4 X 14-1/2 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 76 Craftsman Gunmetal Sockets, 3 Ratchets and 56 Accessories:
(10) 1/4-drive 6-point sizes from 5/32 to 9/16
(10) 1/4-drive 6-point deep sizes from 5/32 to 9/16
(16) 3/8-drive 6-point sizes from 3/16 to 1 in
(16) 3/8-drive 6-point deep sizes from 3/16 to 1 in
3/8-drive spark plug socket, size 5/8 (Craftsman 82-031)
3/8-drive spark plug socket, size 13/16 (Craftsman 82-032)
(11) 1/2-drive 6-point sizes from 3/8 to 1 in
(11) 1/2-drive 6-point deep sizes from 3/8 to 1 in
1/4-drive 120-tooth pear head ratchet (Craftsman 82-010)
3/8-drive 120-tooth pear head ratchet (Craftsman 82-011)
1/2-drive 120-tooth pear head ratchet (Craftsman 82-012)
1/4-drive universal joint (Craftsman 82-014)
3/8-drive universal joint (Craftsman 82-015)
1/2-drive universal joint (Craftsman 82-016)
1/4-drive to 1/4 hex bit adapter (Craftsman 81-872)
(22) screwdriver bits in two holders
(8) nut drivers bits from 3/16 to 1/2
(14) hex keys from 3/64 to 5/16 in holder
(8) short arm hex keys from 1/16 to 1/4 in holder
This tool organizer was designed to fit the inch sockets, hex keys and some of the drive tools from the 282-pc Craftsman gunmetal chrome mechanics tool set (CMMT45282). It was created for Craftsman top chests that don't include a taller drawer.
22-1/4 X 14-1/2 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 14-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.