Contact Us |
Drawing and Part Number Lookup
920-569-0140
Foam Tool Organizer for
48 Tekton 1/4-drive Sockets with 1 Ratchet and 5 Drive Tools
Overview
48 Tekton 1/4-drive Sockets with 1 Ratchet and 5 Drive Tools
Fits (22) inch sockets, (26) metric sockets, 1/4-drive ratchet, (2) extensions, (1) spinner handle, 1/4-drive swivel, and 1/4-drive hex bit holder.
Accommodates the 1/4-drive sockets and drive tools (minus case) from the Tekton 55-pc set SKT05301.
Drawer Size
12 X 18 inches
$36.60
Details
- Drawer size: 12 X 18 inches (inside width by inside depth)
- Standard colors: black/red, blue/yellow, black/blue
- Made from closed-cell polyethylene tool foam.
- Precision CNC-cut to fit 54 Tekton sockets and other tools:
(11) 1/4-drive deep 6-point sizes from 5/32 to 9/16
(11) 1/4-drive 6-point sizes from 5/32 to 9/16
(13) 1/4-drive deep 6-point sizes from 4 to 14
(13) 1/4-drive 6-point sizes from 4 to 14
1/4-drive 90-tooth quick-release ratchet
1/4-drive 6 inch spinner handle
1/4-drive X 3 extension bar
1/4-drive X 6 extension bar
1/4-drive universal joint
1/4-drive hex bit holder
Free shipping on all orders within the contiguous 48 US states.
Made in the USA!
note: tools are not included
Tool Requirements
This tool organizer was designed to fit the 1/4-drive sockets, ratchet, and drive tools from the Tekton 55-pc set SKT05301.
Possible Modifications
Minimum trimmable size:
9-1/4 X 15-3/4 inches
Note: Trimmed organizers are not returnable.
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
Colors by special request:
black/yellow, black/green, black/gray
contact customer service to order this organizer in a special color.
Drawing
Please verify this organizer fits your tools before placing an order.
- Download the drawing: www.FoamFitTools.com/product/F-03246-R.pdf
- Print the pages of the drawing full size or 100% (not fit).
- Check that the printout is full size by measuring the border with a ruler.
- Assemble the pages and place the printed drawing in your toolbox drawer.
- Place the tools over the printed outlines. Visually check that each tool fits within its outline.
Additional Information
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.
