Fits (5) extreme grip style wrenches, (2) locking adjustable wrenches, and (20) ignition wrenches.
Accommodates the extreme grip style wrenches and ignition wrenches from the Craftsman 903-pc set 21470.
Drawer Size
22-1/4 X 14-1/2 inches
$51.40
larger image
note: tools are not included
Precision CNC-cut to fit 27 Craftsman wrenches:
3/8, 10mm extreme grip wrench (Craftsman 12759)
7/16, 11mm extreme grip wrench (Craftsman 15415)
1/2, 12mm, or 13mm extreme grip wrench (Craftsman 12760)
9/16, 14mm extreme grip wrench (Craftsman 12761)
5/8, 15mm, or 16mm extreme grip wrench (Craftsman 12762)
8-inch extreme grip locking adjustable wrench (Craftsman 42354)
10-inch extreme grip locking adjustable wrench (Craftsman 13272)
inch ignition wrenches sizes:
5/32 (Craftsman 42320)
3/16 (Craftsman 42321)
13/64 (Craftsman 42322)
7/32 (Craftsman 42323)
15/64 (Craftsman 42324)
1/4 (Craftsman 42325)
9/32 (Craftsman 42326)
5/16 (Craftsman 42327)
3/8 (Craftsman 42328)
7/16 (Craftsman 42329)
metric ignition wrenches sizes:
4 (Craftsman 42340)
4.5 (Craftsman 42341)
5 (Craftsman 42342)
5.5 (Craftsman 42343)
6 (Craftsman 42344)
7 (Craftsman 42345)
8 (Craftsman 42346)
9 (Craftsman 42347)
10 (Craftsman 42348)
11 (Craftsman 42349)
This tool organizer was designed to fit the extreme grip style wrenches and ignition wrenches from the Craftsman 903-pc set 21470.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 14-1/2 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-3/4 X 13-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.