Fits (6) slotted screwdrivers, (6) Phillips screwdrivers, (5) inch nut drivers, (5) metric nut drivers.
Drawer Size
24 X 18 inches
$66.00
larger image
note: tools are not included
Precision CNC-cut to fit 22 Wright screwdrivers and nut drivers:
Slotted screwdrivers:
1/8 X 3 (Wright 9112)
3/16 X 4 (Wright 9115)
1/4 X 1-1/2 (Wright 9122)
1/4 X 6 (Wright 9124)
5/16 X 6 (Wright 9125)
3/8 X 8 (Wright 9135)
Phillips screwdrivers:
P0 X 3 (Wright 9103)
P1 X 3 (Wright 9104)
P2 X 1-1/2 (Wright 9101)
P2 X 4 (Wright 9105)
P2 X 8 (Wright 9108)
P3 X 6 (Wright 9106)
inch nut drivers:
1/4 (Wright 9222)
5/16 (Wright 9224)
11/32 (Wright 9225)
3/8 (Wright 9226)
7/16 (Wright 9227)
metric nut drivers:
5 mm (Wright 9238)
6 mm (Wright 9240)
7 mm (Wright 9241)
8 mm (Wright 9242)
10 mm (Wright 9244)
We designed this organizer to fit the large Wright screwdrivers with dark red handles. The Wright nut drivers also have a large hard plastic handle.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
24 X 18 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22-1/4 X 16-1/8 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.