Fits (8) solid joint pliers from set 50494,
6-3/4 inch slip joint pliers,
9-1/2 inch arc joint pliers,
(1) retaining ring pliers,
and (1) wire stripper.
Drawer Size
22-1/4 X 16-1/4 inches
$55.20
larger image
note: tools are not included
Precision CNC-cut to fit 12 Craftsman pliers:
8 inch duck bill (Craftsman 45087)
8 inch long reach (Craftsman 45085)
8 inch long nose (Craftsman 45103)
6 inch long nose (Craftsman 45102)
6-1/2 inch bent nose (Craftsman 45104)
6-3/4 inch slip joint pliers (Craftsman 45378)
9-1/2 inch arc joint pliers (Craftsman 45381)
6 inch diagonal cutter (Craftsman 45075)
7 inch diagonal cutter (Craftsman 45076)
7 inch linesman (Craftsman 45093)
internal/external retaining ring pliers (Craftsman 47412)
wire cutter/stripper pliers (Craftsman 73573)
The pliers listed above were available as Craftsman 8-piece set 50494 plus Craftsman 6-3/4-inch slip-joint pliers 45378, 9-1/2-inch arc-joint pliers 45381, snap-ring pliers 47412, and wire stripper 73573.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
22 X 15-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.