Fits (14) wrenches:
6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19
Accommodates the full-polish (long-pattern) metric combination wrenches from the Craftsman 500-piece mechanics tool set 34500.
Drawer Size
22-1/4 X 16-1/4 inches
$55.20
larger image
note: tools are not included
Precision CNC-cut to fit 14 Craftsman combination wrenches:
metric combination wrench sizes:
6 (Craftsman 47981)
7 (Craftsman 45986)
8 (Craftsman 45987)
9 (Craftsman 45988)
10 (Craftsman 45989)
11 (Craftsman 45990)
12 (Craftsman 45991)
13 (Craftsman 45992)
14 (Craftsman 45993)
15 (Craftsman 45994)
16 (Craftsman 45995)
17 (Craftsman 45996)
18 (Craftsman 45997)
19 (Craftsman 45998)
This tool organizer was designed to fit the metric combination wrenches from the Craftsman 500-piece set 34500. The pockets are sized to fit the full-polish, long-pattern wrenches that don't have "USA" markings.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-1/4 X 13-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.