Fits (38) inch 3/8-drive sockets,
(41) metric 3/8-drive sockets,
(2) spark plug sockets,
(1) ratchet,
and (3) extensions.
Accommodates the 3/8-drive sockets and drive tools from the 302-piece mechanics tool set 48302.
Drawer Size
22-1/4 X 10-5/8 inches
$51.50
larger image
note: tools are not included
Precision CNC-cut to fit 81 Craftsman sockets and additional tools:
(13) 3/8-drive 6-point sizes from 1/4 to 1
(5) 3/8-drive 8-point sizes from 1/4 to 1/2
(11) 3/8-drive 12-point sizes from 1/4 to 7/8
(9) 3/8-drive 12-point deep sizes from 3/8 to 7/8
(2) 3/8-drive spark plug socket sizes 5/8, 13/16
(17) 3/8-drive 6-point sizes from 6 to 22
(13) 3/8-drive 12-point sizes from 8 to 19 plus 21
(11) 3/8-drive 12-point deep sizes from 9 to 19
3/8-drive thin-profile ratchet (Craftsman 44995)
1-1/2-inch extension bar, 3/8-drive (Craftsman 43537)
3-inch extension bar, 3/8-drive (Craftsman 44264)
6-inch extension bar, 3/8-drive (Craftsman 44261)
This tool organizer was designed to fit the 3/8-drive sockets and drive tools from the Craftsman 302-piece set 48302. The pockets are sized to fit sockets that don't have "U.S.A." markings.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 10-5/8 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-3/4 X 10-1/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.