Fits (43) inch sockets,
(47) metric sockets,
and (2) Torx bit sockets.
Accommodates all 1/2-drive sockets from the 413-piece mechanics tool set 33413.
Recommended for 3-3/4 min drawer height.
Drawer Size
22-1/4 X 14-1/2 inches
$67.70
larger image
note: tools are not included
Precision CNC-cut to fit 92 Craftsman sockets:
(11) 1/2-drive 6-point sizes from 3/8 to 1
(14) 1/2-drive 6-point sizes from 9 to 22
(6) 1/2-drive 8-point sizes from 7/16 to 3/4
(15) 1/2-drive 12-point sizes from 3/8 to 1-1/4
(21) 1/2-drive 12-point sizes from 9 to 27 plus 30 and 32
(9) 1/2-drive 12-point deep sizes from 1/2 to 1
(10) 1/2-drive 12-point deep sizes from 13 to 22
(2) 1/2-drive hex bit sizes 9/16 and 5/8
(2) 1/2-drive hex bit sizes 14 and 17
(2) 1/2-drive Torx bit sizes T55 and T60
This tool organizer was designed to fit the 1/2-drive sockets from the Craftsman 413-piece set 33413. The pockets are sized to fit sockets with "U.S.A." markings.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 14-1/2 inches (inside width by inside depth)
Recommended for a drawer with at least 3-3/4 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-1/2 X 14 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.