Fits (41) 1/4-drive sockets,
(53) 3/8-drive sockets,
and (64) 1/2-drive sockets.
Accommodates all inch sockets from the 299-piece socket set 35299.
Recommended for 3-3/4 min drawer height.
Drawer Size
22-1/4 X 16-1/4 inches
$73.40
larger image
note: tools are not included
Precision CNC-cut to fit 158 Craftsman sockets:
(11) 1/4-drive 6-point sizes from 5/32 to 9/16
(10) 1/4-drive 12-point sizes from 3/16 to 9/16
(10) 1/4-drive 6-point deep sizes from 3/16 to 9/16
(10) 1/4-drive 12-point deep sizes from 3/16 to 9/16
(13) 3/8-drive 6-point sizes from 1/4 to 1
(5) 3/8-drive 8-point sizes from 1/4 to 1/2
(13) 3/8-drive 12-point sizes from 1/4 to 1
(11) 3/8-drive 6-point deep sizes from 3/8 to 1
(11) 3/8-drive 12-point deep sizes from 3/8 to 1
(15) 1/2-drive 6-point sizes from 3/8 to 1-1/4
(6) 1/2-drive 8-point sizes from 7/16 to 3/4
(19) 1/2-drive 12-point sizes from 3/8 to 1-1/2
(11) 1/2-drive 6-point deep sizes from 1/2 to 1-1/8
(13) 1/2-drive 12-point deep sizes from 7/16 to 1-3/16
This tool organizer was designed to fit the inch sockets from the Craftsman 299-piece set 35299. The pockets are sized to fit sockets with "U.S.A." markings.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Recommended for a drawer with at least 3-3/4 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
19-1/4 X 15-3/4 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.