3 Craftsman Ratchets with 28 Drive Tools and Bits
Fits (3) ratchets,
(3) flex handles,
(1) spinner handle,
(2) universal joints,
and (1) magnetic handle with bits.
Accommodates the ratchets and drive accessories from the older version of the 413-piece mechanics tool set 33413.
22-1/4 X 16-1/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 3 Craftsman ratchets with 28 drive tools:
1/2-drive quick release teardrop ratchet (Craftsman 44809)
1/2-drive 15-inch flex handle/breaker bar (Craftsman 44201)
3/8-drive quick release long teardrop ratchet (Craftsman 44808)
3/8-drive 10-inch flex handle/breaker bar (Craftsman 44363)
1/4-drive quick release teardrop ratchet (Craftsman 44807)
1/4-drive 6-inch spinner handle (Craftsman 43372)
1/4-drive 6-inch flex handle/breaker bar (Craftsman 43523)
3/8-drive to 1/2 socket adapter (Craftsman 04258)
3/8-drive to 1/4 socket adapter (Craftsman 04256)
3/8-drive universal joint (Craftsman 04435)
1/4-drive universal joint (Craftsman 04280)
3-inch extension bar, 1/2-drive (Craftsman 44133)
6-inch extension bar, 1/2-drive (Craftsman 44131)
10-inch extension bar, 1/2-drive (Craftsman 44132)
1-1/2-inch extension bar, 3/8-drive (Craftsman 43537)
3-inch extension bar, 3/8-drive (Craftsman 44264)
6-inch extension bar, 3/8-drive (Craftsman 44261)
3-inch extension bar, 1/4-drive (Craftsman 43539)
6-inch extension bar, 1/4-drive (Craftsman 43531)
14-inch extension bar, 1/4-drive (Craftsman 43532)
magnetic handle (Craftsman 43373)
10-piece screwdriver bit set
This tool organizer was designed to fit the ratchets and drive tools from the Craftsman 413-piece set 33413. The pockets are sized to fit older tools which have "U.S.A." markings.
22-1/4 X 16-1/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 21-3/4 X 13-7/8 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.