Fits (13) slotted screwdrivers,
(9) Phillips screwdrivers,
(6) torx screwdrivers,
(1) offset screwdriver,
(1) pocket screwdriver,
and (1) magnetic handle with (10) bits.
Accommodates all tools from the 41-piece screwdriver set 31798.
Drawer Size
22-1/4 X 16-1/4 inches
$55.20
larger image
note: tools are not included
Precision CNC-cut to fit 41 Craftsman screwdrivers:
slotted:
3/32 X 1-1/2, 1/8 X 2, 1/8 X 4, 3/16 X 4, 3/16 X 6, 3/16 X 8, 3/16 X 9, 1/4 X 1-1/2, 1/4 X 4, 1/4 X 6, 1/4 X 8, 5/16 X 8, 3/8 X 8 (left side)
Phillips:
p0 X 1-1/2, p0 X 2-1/2, p1 X 3, p2 X 1-1/2, p2 X 4, P2 X 6, P2 X 8, P3 X 6, P4 X 8 (right side)
torx:
T10, T15, T20, T25, T27, T30
other:
1/4 X p2 combination offset, pocket, magnetic bit driver, 10 piece bit set
This tool organizer was designed to fit all the tools from the 41-piece screwdriver set 31798.
Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.
22-1/4 X 16-1/4 inches (inside width by inside depth)
Works in most drawers, needing no more than 2 inches of vertical clearance.
It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:
21-3/4 X 16 inches
Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.
We make these colors in smaller batches, but they are often in stock. Contact customer service to order.
Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.