FoamFit Tools section divider

Foam Tool Organizer for
16 Craftsman Reversible Ratcheting Wrenches with Sockets

see all organizers for Craftsman ratcheting wrenches


16 Craftsman Reversible Ratcheting Wrenches with Sockets

Fits (8) reversible inch ratcheting wrenches, (8) inch wrench sockets (left side), (8) reversible metric ratcheting wrenches, and (8) metric wrench sockets (right side).

Accommodates the USA-made version of the ratcheting wrenches and wrench sockets from the 540-piece mechanics tool set 36540.

Drawer Size
22-1/4 X 16-1/4 inches


FoamFit Tools section divider


This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 16 Craftsman wrenches and wrench sockets:

inch reversible ratcheting wrenches:
5/16 (Craftsman 42412)
3/8 (Craftsman 42413)
7/16 (Craftsman 42414)
1/2 (Craftsman 42415)
9/16 (Craftsman 42416)
5/8 (Craftsman 42417)
11/16 (Craftsman 42418)
3/4 (Craftsman 42419)
(left side)

metric reversible ratcheting wrenches:
8mm (Craftsman 42420)
10mm (Craftsman 42421)
11mm (Craftsman 42422)
12mm (Craftsman 42423)
13mm (Craftsman 42424)
14mm (Craftsman 42425)
15mm (Craftsman 42426)
16mm (Craftsman 42427)
(right side)

inch wrench sockets: 5/16 3/8 7/16 1/2 9/16 5/8 11/16 3/4 (left side)

metric wrench sockets: 8 10 12 13 14 15 17 18 (right side)

This organizer only fits the USA-marked Craftsman full-polish ratcheting wrenches with reversing levers. This organizer fits the ratcheting wrenches and wrench sockets included in version 1 of the Craftsman 540-piece mechanics tool set 36540.

This organizer is designed to fit a standard Craftsman toolbox drawer with inner dimensions of:

22-1/4 X 16-1/4 inches
(inside width by inside length)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.

Made in the USA!


Note: tools are not included

FoamFit Tools section divider


Please verify this organizer fits your tools before placing an order.

  1. Download the drawing:
  2. Print the pages of the drawing full size (page scaling = none).
  3. Assemble the pages and place the printed drawing in your toolbox drawer.
  4. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider