FoamFit Tools section divider

Foam Tool Organizer for
12 Pliers

see all organizers for Craftsman pliers


12 Pliers

Fits (8) pliers from set 45399,
9-1/2 inch arc joint pliers,
13-inch arc joint pliers,
and (2) Irwin Original Vice Grip pliers.

Drawer Size
22-1/4 X 16-1/4 inches


FoamFit Tools section divider


This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 12 pliers:

6-3/4 inch slip joint pliers (Craftsman 45378)
7 inch diagonal cutter (Craftsman 45076)
7 inch linesman pliers (Craftsman 45093)
8 inch long nose pliers (Craftsman 45103)
8 inch long reach long nose (Craftsman 45085)
4 inch diagonal cutter (Craftsman 45733)
4 inch end nipper (Craftsman 45739)
4-1/2 inch long nose pliers (Craftsman 45738)
9-1/2 inch arc-joint pliers (Craftsman 45381)
13 inch arc-joint pliers (Craftsman 45386)
6 inch long nose Vice-Grip (Irwin 6LN)
7 inch straight or curved nose Vice-Grip (Irwin 7R or 7WR)

The pliers listed above are available as Craftsman 8-piece set 45399, plus 9-1/2-inch arc-joint pliers 45381, 13-inch arc-joint pliers 45386, and 2 Irwin Vice-Grip pliers.

This organizer is designed to fit a standard Craftsman toolbox drawer with inner dimensions of:

22-1/4 X 16-1/4 inches
(inside width by inside length)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.

Made in the USA!

Foam Foam

Note: tools are not included

FoamFit Tools section divider


Please verify this organizer fits your tools before placing an order.

  1. Download the drawing:
  2. Print the pages of the drawing full size (page scaling = none).
  3. Assemble the pages and place the printed drawing in your toolbox drawer.
  4. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider