Drawing and Part Number Lookup | Contact Us 920-569-0140
This organizer is also available without tools: F-05728-T
7 Tekton Hammer Kit #186
This complete kit includes organizer insert F-05728-T and 7 Tekton dead blow hammers.
The tool organizer may be trimmed to fit a variety of drawer sizes. Please compare the minimum recommended size to your drawer size before ordering.
Detailed drawing: F-05728-T.pdf
Tool organizer made in USA. Tools made in USA.
Drawer Size
23-3/4 X 17-3/4 inches
$459.40 sale $434.10
This kit includes the following 7 Tekton hammers:
from 3-pc set HDB93001:
13 oz dead blow hammer (Tekton HDB30013)
21 oz dead blow hammer (Tekton HDB30021)
39 oz dead blow hammer (Tekton HDB30039)
from 3-pc set HDB95002:
36 oz ball pein hammer (Tekton HDB50036)
43 oz short ball pein hammer (Tekton HDB51043)
50 oz long ball pein hammer (Tekton HDB50050)
26 oz flat steel face hammer (Tekton HDB40026)
The foam insert included with this kit measures 23-3/4 X 17-3/4 inches.
It is not possible to compress the foam because the tool pockets will also squeeze closed. The foam sheet can be trimmed with a sharp knife if necessary. Contact customer service if you'd like us to modify the sheet size to your measurements.
The minimum recommended size for trimming is 21-1/2 X 15-13/16 inches. This leaves a margin of approximately 1/4-inch. Trimmed organizers are not returnable.
"Our goal with this kit was to incude a good selection of low-rebound hammers that would be useful in an idustrial setting for working on machines and tooling. We included both plastic-faced and steel-faced hammers in a variety of lengths."
After test fitting each kit, we remove the tools and seal them in a heavy-duty bag for shipping. We include a drawing to help place each tool back in the foam.
back to kits with hammers
back to kits with tools main page
view the full selection of foam tool organizers