Foam Tool Organizer for
47 Husky Metric Impact Sockets

Overview

47 Husky Metric Impact Sockets

Fits (18) 3/8-drive impact sockets and (29) 1/2-drive impact sockets.

Accommodates the metric impact sockets and drive tools from the Husky 1025-pc set H1025MTS.

Drawer Size
12-5/8 X 18-1/2 inches

$41.10



Foam Organizer for 47 Husky Metric Impact Sockets

larger image

Foam Organizer for 47 Husky Metric Impact Sockets

larger image

note: tools are not included

Tool List

Precision CNC-cut to fit 47 Husky impact sockets:

(9) 3/8-drive 6-point metric impact sizes 10 - 15, 17, 19 mm
(9) 3/8-drive 6-point metric impact deep sizes 10 - 15, 17, 19 mm
(11) 1/2-drive 6-point metric impact sizes 13 - 19, 21, 22, 24, 27 mm
(11) 1/2-drive 6-point metric impact deep sizes 13 - 19, 21, 22, 24, 27 mm
(7) 1/2-drive hex bit impact sizes from 9 to 15 mm

Tool Notes

This organizer was designed to fit the metric impact sockets and drive tools from the Husky 1025-pc set H1025MTS.

Drawing

Drawing F-03732-R.pdf

Printing the drawing at 100% scale can be an easy way to check if your tools will fit. Our drawings have multiple pages which can be printed on letter-size paper. Always change the printer setting from "fit" to 100%. If the border prints slightly too small, it is often due to this setting.

Part of Collection

Organizers for Husky 1025-pc set, 52-inch toolbox #2

Drawer Size

12-5/8 X 18-1/2 inches (inside width by inside depth)

Drawer Height

Works in most drawers, needing no more than 2 inches of vertical clearance.

Minimum Trimmable Size

It is possible to trim the margins to fit a smaller drawer. Trimmed tool organizers are not returnable. The minimum recommended size is:

12-3/8 X 18 inches

Contact customer service to order this organizer cut on a larger sheet or trimmed to a special size.

Features and Benefits

Standard Colors

black over red color combination blue over yellow color combination black over blue color combination

Special Colors

We make these colors in smaller batches, but they are often in stock. Contact customer service to order.

black over yellow color combination black over green color combination black over gray color combination

Additional Information

Each FoamFit insert is designed for shadowing a specific brand and set of tools. These organizers are made from high-quality tool foam with pockets precision-cut on our CNC routers.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. The foam is resistant to most oils and fuels.

Free Shipping!

For orders within the contiguous 48 US states.

US flag

Made in the USA!