34 Husky Inch Combination, Ratcheting and Ignition Wrenches
Fits (17) combination, (7) non-reversable ratcheting, and (10) ignition wrenches.
Accommodates all inch wrenches from the Husky 432-pc set H432MTS.
33-15/16 X 19-3/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 34 Husky wrenches:
inch non-reversable ratcheting:
inch ignition wrenches:
This tool organizer was designed to fit the combination, ratcheting, and ignition wrenches from the Husky 432-pc set H432MTS.
33-15/16 X 19-3/4 inches (inside width by inside depth)
It is possible to trim this organizer to fit a smaller drawer. The minimum recommended size is 32-1/8 X 18-1/4 inches. Note that trimmed organizers are not returnable. Also, contact customer service to order an organizer trimmed or made with a different sheet size.
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.