FoamFit Tools section divider

Foam Tool Organizer for
29 Craftsman Flare-Nut, Obstruction, and Ignition Wrenches, Fits non-USA Wrenches

see all organizers for Craftsman specialty wrenches

Overview

29 Craftsman Flare-Nut, Obstruction, and Ignition Wrenches, Fits non-USA Wrenches

Fits (4) inch flare-nut wrenches,
(1) obstruction wrench,
(4) metric flare-nut wrenches,
(10) inch ignition wrenches,
and (10) metric ignition wrenches.

Accommodates the flare-nut, obstruction, and ignition wrenches from the Craftsman 348-piece mechanics tool set 49348 or the 444-piece set 34444.

New!

Drawer Size
22-1/4 X 14-1/2 inches

$39.00



FoamFit Tools section divider

Details

This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 29 Craftsman wrenches:

inch flare-nut wrenches:
3/8 X 7/16 (Craftsman 42091)
1/2 X 9/16 (Craftsman 42092)
5/8 X 11/16 (Craftsman 42093)
3/4 X 7/8 (Craftsman 42094)

obstruction wrench:
9/16 X 5/8 (Craftsman 47463)

metric flare-nut wrenches:
10 X 12 (Craftsman 42096)
13 X 14 (Craftsman 42097)
15 X 17 (Craftsman 42098)
16 X 18 (Craftsman 42099)

10-pc inch ignition wrench set (Craftsman 42319)
10-pc metric ignition wrench set (Craftsman 42339

This tool organizer was designed to fit the flare-nut, obstruction, and ignition wrenches from the Craftsman 348-piece set 49348 or the 444-piece set 34444. The pockets are sized to fit tools that don't have "USA" markings.

This organizer is designed to fit a standard Craftsman toolbox drawer with inner dimensions of:

22-1/4 X 14-1/2 inches
(inside width by inside length)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.



Made in the USA!

Foam

Note: tools are not included

FoamFit Tools section divider

Drawing

Please verify this organizer fits your tools before placing an order.

  1. Download the drawing: www.FoamFitTools.com/product/F1M-01447.pdf
  2. Print the pages of the drawing full size (page scaling = none).
  3. Assemble the pages and place the printed drawing in your toolbox drawer.
  4. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider