FoamFit Tools section divider

Foam Tool Organizer for
16 Craftsman Inch Combination Wrenches on Edge

see all organizers for Craftsman combination wrenches

Overview

16 Craftsman Inch Combination Wrenches on Edge

Fits (16) raised-panel inch combination wrenches.

Note: this organizer fits the raised-panel combination wrenches from the Craftsman 26-piece set (see Craftsman 46935).

Caution: Recommended for a 3-inch or deeper drawer.

Will also fit older Craftsman combination wrenches with "U.S.A." markings.

New!

Drawer Size
22-1/4 X 10-5/8 inches

$46.00



FoamFit Tools section divider

Details

This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 16 Craftsman wrenches:

inch combination wrenches:
1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, 1, 1-1/16, 1-1/8

This tool organizer was designed to fit the raised-panel wrenches from the Craftsman 26-piece set 46935. The pockets will also fit older Craftsman combination wrenches with "U.S.A." markings.

This organizer is designed to fit a standard Craftsman toolbox drawer with inner dimensions of:

22-1/4 X 10-5/8 inches
(inside width by inside length)

free shipping within the contiguous 48 US states

Free shipping on all orders within the contiguous 48 US states.



Made in the USA!

Foam

Note: tools are not included

FoamFit Tools section divider

Drawing

Please verify this organizer fits your tools before placing an order.

  1. Download the drawing: www.FoamFitTools.com/product/F1A-01151.pdf
  2. Print the pages of the drawing full size (page scaling = none).
  3. Assemble the pages and place the printed drawing in your toolbox drawer.
  4. Place the tools over the printed outlines. Visually check that each tool fits within its outline.

Additional Information

Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.

The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).

Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.

Black and Red, Blue and Yellow, and Black and Blue Tool Foam
FoamFit Tools section divider