3 Craftsman Teardrop Ratchets with Magnetic Bit Set and Igniton Wrenches, Fits non-USA Ratchets
Fits (3) ratchets,
(1) magnetic handle,
(9) screwdriver bits,
(12) nut driver bits,
(10) inch ignition wrenches,
and (10) metric ignition wrenches.
Accommodates the ratchets, drive tools, and ignition wrenches from the newer version of the 309-piece mechanics tool set 41309.
22-1/4 X 16-1/4 inches
This foam tool organizer is made from closed-cell polyethylene tool foam. It has been precision CNC-cut to fit the following 52 Craftsman ratchets, drive tools, and ignition wrenches:
1/2-drive quick-release teardrop ratchet (Craftsman 44809)
3/8-drive quick-release long teardrop ratchet (Craftsman 44808)
1/4-drive quick-release teardrop ratchet (Craftsman 44807)
1-1/2-inch extension bar, 1/4-drive (Craftsman 43538)
3-inch extension bar, 1/4-drive (Craftsman 43539)
1-1/2-inch extension bar, 3/8-drive (Craftsman 43537)
3-inch extension bar, 3/8-drive (Craftsman 44264)
6-inch extension bar, 3/8-drive (Craftsman 44261)
3-inch extension bar, 1/2-drive (Craftsman 44133)
Magnetic Bit Handle (Craftsman 43373)
(3) Slotted Screwdriver Bits: 5/16, 1/4, 9/32
(3) Phillips Screwdriver Bits: P1, P2, P3
(2) Torx Screwdriver Bits: T15, T20
(1) Square Screwdriver Bit: R2
(1) Adapter Bit, Magnetic Handle to 1/4-Drive Socket
(7) Nut Driver Bits, Inch Sizes: 3/16, 1/4, 9/32, 5/16, 11/32, 3/8, 7/16
(5) Nut Driver Bits, Metric Sizes: 5, 6, 8, 10, 11
(10) Inch Ignition Wrenches: 5/32 to 7/16 (Craftsman 42320 to 42329)
(10) Metric Ignition Wrenches: 4mm to 11mm (Craftsman 42340 to 42349)
This tool organizer was designed to fit the ratchets, drive tools, and ignition wrenches from the Craftsman 309-piece set 41309. The pockets are sized to fit newer tools which do not have "U.S.A." markings.
This organizer is designed to fit a standard Craftsman toolbox drawer with inner dimensions of:
22-1/4 X 16-1/4 inches
(inside width by inside length)
Note: tools are not included
Each FoamFit insert is designed for shadowing a specific set of tools. These organizers are made from high-quality tool foam with precision-cut pockets.
The pockets are cut up to 1/2 inch deep in 3/4 inch thick tool foam, or up to 1 inch deep in 1-1/4 inch thick tool foam. Most inserts require less than 2 inches of height to fit in a 2-inch drawer (unless otherwise noted).
Our tool foam is two layers of closed-cell polyethylene foam. The contrasting top layer is thermally bonded to the bottom layer for maximum durability. Three color combinations are available: black with red, blue with yellow, and black with blue. The foam is resistant to most oils and fuels.